@dc42
I’m on 2.0 can i still use M581? It keeps throwing it to Emergency Stop.
All I need it tot do:
Filament present : print goes on normally
Filament absent: trigger pause , wait for filament, purge
Similar to M600 in Marlin
Do I need to rewrite pause.g with M701 and M702 ?
Thanks
I’m on 2.0 can i still use M581? It keeps throwing it to Emergency Stop.
All I need it tot do:
Filament present : print goes on normally
Filament absent: trigger pause , wait for filament, purge
Similar to M600 in Marlin
Thanks
It just said simple filament sensor on endstop4 , disable, output liw when no filament
Nothing really change whether filament is in or not.
What does it actually do? Does it trigger a stop?
I have a simple sensor. A micro switch wired to be NC, so when filament is present , the switch would be open.
I have this
M591 D3 P2 C3 S1 ; E-0 watcher
M591 D4 P2 C4 S1 ; E-1 watcher
I had D0 and D1 before but nothing happened. Where & how should I input this in my config?
I have seen this thread
https://forum.duet3d.com/topic/4699/are-you-using-a-filament-sensor-with-your-duet/6
It’s actual what I want to do as someone mentioned m581
Do I have to insert m581 m582 in a particular order ? In config.g?
Can someone share what it should look like?
I'm trying a simple sensor with m591 and got nothing...
The original post is locked so I have to make a new thread to ask.
@t3p3tony TB6600 does not work.
I have to change to a more expensive DM542S
I have it running now. At 32x , it runs ebrry time now. 128x doesn’t work.
@t3p3tony
Yes this is on external drivers(xyz) so m350 for xyz doesn’t matter but the m92 steps per unit (mm) is the deciding factor?
Thanks a bunch!
@dc42
I got it to run!!!
Now here is a new issue. When I run test all motors, I edited to have 32x microstepping. An error pop up saying M350 drive Z does not support 32x microstepping... what is the deal?
@dc42 I tried. I think my driver is bad. I'm buying new ones. I will report the results soon
Thanks so much