Best posts made by Melfesto

Hey, all got a question about stepper motors. Is there such a thing as best for precision. Like If you were to build a printer and money wasn't a problem what would be the best stepper motor you would buy and why?

Hi all. Trying to figure out what is causing to happen on my ender 5 config with the duet 2 wifi board.

looks like you might be right on the thermistor values.

10:18:06 AMWarning: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicted to reach 219C.
Auto tune heater 0 completed in 1000 sec
Use M307 H0 to see the result, or M500 to save the result in config-override.g
10:06:30 AMAuto tune phase 3, peak temperature was 100.2
10:06:23 AMAuto tune phase 2, heater off
10:01:31 AMAuto tune phase 1, heater on
10:01:25 AMM303 H0 S100
Auto tuning heater 0 using target temperature 100.0°C and PWM 1.00 - do not leave printer unattended
9:59:52 AMWarning: Heater 1 appears to be over-powered. If left on at full power, its temperature is predicted to reach 494C.
Auto tune heater 1 completed in 231 sec
Use M307 H1 to see the result, or M500 to save the result in config-override.g
9:57:42 AMAuto tune phase 3, peak temperature was 249.4
9:57:33 AMAuto tune phase 2, heater off
9:56:06 AMAuto tune phase 1, heater on
9:56:01 AMM303 H1 S240
Auto tuning heater 1 using target temperature 240.0°C and PWM 1.00 - do not leave printer unattended

going to try another cube and will drop the temp to 215 nozzle and 60 bed and see if this has helped any. The reason i went with 220 on this is with the old marlin board that came with the system it printed the best at this temp for the amazon basic black pla. The reason i switched over to duet was the system was so loud printing and i wanted a quieter system with better controls. will post up the result of the new print when they are done.