Topics created by Leblond

@Phaedrux
Thanks guy, the problem was that I didn't know that when you do a G32 that then it goes to call the BED.G
the probe does not activate in the moment of fast descent towards the floor, but it activates in the moment in which it proceeds with the probing coordinates, I thought that the probe activated in the moment in which the G32 command is given, while if the command is given G30 followed by the coordinates the probe is active

@fcwilt ok grazie

even the temperatures will have to lower by 5 degrees, petg mold at 230 degrees the print bed 75 degrees

Move and Axes are part of the object model which is used to query various parameters

https://duet3d.dozuki.com/Wiki/Object_Model_of_RepRapFirmware

Think of it like a tree or a flow chart.
Each object may branch out into other objects.
Where it's necessary to identify the same parameter on many tools or axes, each one is allocated a unique identifier in an array. Arrays are surrounded by square brackets [ ]

In the case of move.axes[0].min
It will give the the axis minima you set for axis 0. (X) in your config.g using M208
move.axes[1].min would be Y minima.

You can the use curly brackets { } to allow you to do math based on the values.

This allows you to write macros which will automatically update if you were to change the value in M208 for example

@Veti 😲 I assure you that you are wrong, the bearings are "u" groove, I have to disassemble them to see their dimensions

thanks you guys

ok thanks now i try

@dc42 all right

I am speechless, mea culpa I have redone all the cables of the duet from the first to the last being careful of all the connections, this one I ran away, as the title of the post I am really ROGOGIONED, thank you very much. At least I know I haven't burned anything

thanks anyway

@Phaedrux 20200422_000026.jpg

Untitled.pdf

@bearer 👍

grazie ragazzi Risolto

Thanks for your help !
Problem 2: With “T0” to the end of config.g all work perfect.

Problem 1: I find the problem: now work all good !!!

; homeall.g
; called to home all axes
G91 ; relative positioning
G1 H2 Z5 F6000 ; lift Z relative to current position
G1 H1 X-235 Y-228 F3000 ; move quickly to X and Y axis endstops and stop there (first pass)
G1 H2 X5 Y5 F6000 ; go back a few mm
G1 H1 X-235 Y-228 F240 ; move slowly to X and Y axis endstops once more (second pass)
THIS IS TE PROBLEM !!! G1 H1 Z-255 F240 ; an old command in RRF2
G90 ; absolute positioning
G1 X110 Y110 F3600 ; Posiziono la sonda al centro del piatto
G30 ; Sondo il piatto con il BLTouch
;END

Thanks again !