@Phaedrux Ok I will more than likely need some assistance fine tuning the mesh leveling to match my probe locating and the areas where the print head can move off the bed. I did find this post in the forums where you made some good references that I think will get me there though.
https://forum.duet3d.com/topic/18185/possible-pwm-port-issue-rrf3-question/18
@Phaedrux So not sure exactly what it was but my guess is the low acceleration on the z axis as you pointed out should be raised to 60. I placed 3mm of carbon under the front to exaggerate the needed compensation and it seems to be following it pretty well. there are a few spots where it sill print just a little too high but I will try increasing the probe points to see if it improves on it. But overall its usable so im happy. thanks again for helping.
@Phaedrux Seems I got the bed mesh dialed in pretty good. I used previous Hight maps to adjust the bed mounting points and this is my result. Sure its not %100 perfect but I will take it. Hopefully that is the last of the assistance I need. Thanks again for your patience and professionalism 
@Kwad3d Ok Im Good. Sorry for the false alarm. It was all just a Typo error on my part holding me back