Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
You'd need to type and hit enter on each field for the new temp to be applied. if you do this while the heater is still heating up, the update may show with a delay.
@Johnnie_W said in Duet 3 6HC - using temp sensor without mapping to a heater:
Is it possible to use a temp sensor without having to map it to a heater?
Yes. In RRF3 sensors are defined independently of heaters. You can display them in DWC if you click on Extras.
@Johnnie_W
What version of the firmware are you using.
With version 3.4.x a filament sensor triggers an event which needs to be handled:
RRF Events
Perhaps something is missing from your configuration.
Frederick
