Topics created by edsped

@edsped said in M116 and temperature overshoots...:

@deckingman That works well enough for the initial tool but not sure if it would be good for tool changes during the print.

You can read the active temperature for a tool using the object model e.g in your tool change macro use tools[n].active[0] and use that instead of a fixed value.

@Herve_Smith

I think I have about 8' per tool but am hoping reduce that by using the CAN setup. If you can't tell I'm a bit out of my league on this. I'm beyond busy at the moment but my next step is to setup some sort of bench test setup and play with it for a bit before stripping down my machine.

Just a quick addition…. The duet Wi-Fi and duet3 w/SBC are in two separate networks. WiFi was on a 2.4 GHz and SBC is on a 5GHz both managed by two separate ubiquiti UAP’s