Topics created by dingo007

The measurement doesn't need to be 100% exact to work either. The closer the better, but don't fret over half a mm.

@dingo007

Glad to hear all is working.

Just FYI that M574 for Z is not needed.

From the docs:

The S2 option of M574 is intended for use only when axes other than Z are using the Z probe for homing. The only printers known that do this using Duet electronics are the RepRapPro Ormerod, Huxley Duo, and Mendel Tricolour machines. When using the Z probe to home Z, M574 Z has no bearing on the probe setup or usage. A Z probe and a Z endstop can both be configured at the same time. G30 calling the probe setup with M558, and G1 H1 Z moves calling the endstop configured with M574 Z.

Frederick

@dingo007 Yupp thats resolved now... all motors working

Bingo... that worked, have GUI now Thanks

@dingo007
@Veti
I would like to come back to this issue, just to clarify.
It's also possible to configure the heater to H1 as we have suggested.
I have tested that today, it works.
As well I have checked the RRFCT configuration.
For that case, the tool configuration wasn’t generated correctly.

It also seems if multiple subsequent modifications are done by adding/deleting heater or tools the config.g is getting weirder.
It helped to clean up the browser cash.

this has to be answerd by dc

@dingo007 said in Z axis off, Layers to tall.....:

how does a single end stop provide a truey level bed.

not by using an endstop, but a probe.

the dual endstop feature is only really supported in rrf3

there is a workaround in rrf2 by splitting the axis up during homing, but there is no point setting that up anymore in my opinion.

@Veti Yupp got it, that was the issue... resolved now. Thanks just had to reverse 2 pins on each motor. Thanks