Topics created by Cts519

I have kapton tape, about 5 layers, on the back of it. I also wrapped my heat block with the tape. It would take a lot to hit it, so no protection there.

I have both a 7" and a 5" (Both from Filastruder).

Honestly, the 5" is just fine.

The PanelDue cable on my delta is more than 1.5m long. It's 4 core unshielded cable.

A bit of topic but not too far IMO:

How about connecting 4 motors on a single (external) driver? To maintain the needed voltage same, would it work connecting 2 pairs in series and then those pairs parallel?

Just poundering the simplest way to make my bed move with 4 motors.