Topics created by crc1337

Thanks for the tips. That's a great idea of adjusting the parameters every 10 layers, I will give that a try. I am running the same accel and jerk settings on the other axes but have not spent any time tuning these and have been happy with the performance until I tried to use pressure advance.

@T3P3Tony:

cchaffee, ignore my previous comment, Tim is all over this.

Great, thanks guys. I will stand by and await further instructions.

ahh that may well bit. For clarification the PT100 chip cancels out the signals it sees on both wires on each side, if they are following different paths they are going to have different noise on them which will mess with the results.

@peridot:

Would it be feasible - this is a firmware question I guess - to respond to probe triggers when not probing? With the accelerometer set right you might be able to detect head crashes and stop the print. Obviously this doesn't make sense for all sensor designs.

Yes, if the acceleration in fast travel moves can be distinguished well enough from the abnormal situations you wan to detect.

Seems the board does not accept wifi passwords if they have a + in them. Confirmed this with another router, tested various password lengths and combinations of alphanumeric and non-alphanumeric characters, everything works fine until you try to use a password with a plus in it. Unfortunately my board will remain on the shelf until this is fixed.