Topics created by carlitototo

sorry for the late response !
Removing B1 worked perfectly !

Well that's a problem...I read this thread https://forum.duet3d.com/topic/8690/keep-hotend-off-until-after-bltouch-finishes-bed-leveling/6 and read a little more on the subject, I'm going to stick with B1 🙂

Forgot to ask... Can the firmware account for belt elongation ? I saw this : Belt_Compliance_Measurement and it seems long belts can be an issue with precision, is there a way to compensate for such a thing ?

Welcome to the Duet and RepRapFirmware. You've only scratched the surface.

ok, found the solution, tried with enabled pin in and out didn't work, but tried something rather simple after seeing this dozuki page ( I don't know how I missed it before ! )... rather than connecting the TB6600 GND to the E2_STOP, I connected it directly to the GND on pin number 2... works perfectly now !

so the correct pin layout for me was :
E2_EN to EN
E2_DIR to DIR
E2_STEP to CLK
GND to GND

and for the mode selection on the TB6600 :
M1 ON
M2 ON
M3 OFF
TQ OFF ( AUTO )

I'm so happy this finally works !

<Thanks @CNCModeller 🙂

@carlitototo said in Using External Drivers for X/Y/Z Axis:

It is my understanding that I need to remap the drivers pins, but I'm kinda stuck on the chart near the end of the page, not really shure what the X/Y/Z axis pin is on the duet... same for the E"number" axis pin, on the expansion slot there are 4 pins for each "E" !

Yes, use the E2, E3 and E4 pins (aka driver 5, driver 6 and driver 7 pins).

@carlitototo said in Messed up duet wifi installation !:

Infortunatly, nothing will do ! still no ports recognize, after trying tothe erase procedure multiple times... Sad to say, but I think (3D :P) that my duet is dead snif

Try a different USB port on your PC if you haven't already, also try rebooting the PC - especially if it is running Windows. If you've already done that, then go ahead and contact your supplier.

Thanks for the clue ^^