Using External Drivers for X/Y/Z Axis
-
Hello,
Merry Christmas !
Was tinkering around wanting to connect an MKS TB6600 to my Duet, and I found this page on the wiki.
It is my understanding that I need to remap the drivers pins, but I'm kinda stuck on the chart near the end of the page, not really shure what the X/Y/Z axis pin is on the duet... same for the E"number" axis pin, on the expansion slot there are 4 pins for each "E" !
So not shure what to do... any genius ideas
?Thank you so much and happy holydays !
-
try this setting
; Drives
; M569 P0 S0 ; Drive 0 goes forwards=0 BACKWARD = 1 0==X
;M569 P1 S1 ; Drive 1 goes forwards=0 BACKWARD = 1 1==Y
M569 P2 S1 ; Drive 2 goes forwards=0 BACKWARD = 1 2==Z
M569 P3 S0 ; Drive 3 goes forwards=0 BACKWARD = 1 3==E
M569 P4 S1
M569 P5 R1 T2.5:2.5:5:0
M569 P6 R1 T2.5:2.5:5:0
M569 P7 R1 T2.5:2.5:5:0
M569 P8 R1 T2.5:2.5:5:0M584 X7 Y8
I use this setting to drive dm542t
-
@carlitototo said in Using External Drivers for X/Y/Z Axis:
It is my understanding that I need to remap the drivers pins, but I'm kinda stuck on the chart near the end of the page, not really shure what the X/Y/Z axis pin is on the duet... same for the E"number" axis pin, on the expansion slot there are 4 pins for each "E" !
Yes, use the E2, E3 and E4 pins (aka driver 5, driver 6 and driver 7 pins).
