Topics created by bastien

You can use this guide to find the motor phase pairs

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Motors_connecting#identifying-the-stepper-motor-phases

And any time you have issues with a delta, it's good to go over the basic calibration steps.

https://docs.duet3d.com/en/User_manual/Tuning/Delta_calibration

@bberger said in firmware retraction:

this. the 3.4 betas are known (and confirmed) to have a retraction issue..

it's ok after update thanks

@siam it works, in config after line 68, thanks

3.2.2 here, I can confirm I also got stuck with wifi at 1.23, and running the command M997 S1 two times started the flashing properly.

Now I got 1.25... found the answer here.

@jay_s_uk thanks

I just picked up a few of these fysetc panels (LCD800480 V1.1). The important thing to look at is that yes its more like a paneldue 7i in form factor, but the back of the pcb says it is based on the paneldue v3 not the 7i. So once I flashed the board with PanelDue-v3-7.0.bin files everything was as expected now.

in reprap configurator , i haved select high but in config.g is low

; Endstops M574 X2 S1 P"xstop" ; configure active-high endstop for low end on X via pin xstop M574 Y2 S1 P"ystop" ; configure active-high endstop for low end on Y via pin ystop M574 Z2 S1 P"zstop" ; configure active-high endstop for low end on Z via pin zstop

first probleme resolved