Topics created by avery1701

Back to basics https://docs.duet3d.com/en/User_manual/Tuning/Delta_calibration

@avery1701 I second the recommendation to use a Meanwell or similar quality PSU. My delta a originally used a cheap no-name Chinese PSU. After quite a lot of use, a strange smell started coming from it. On investigation, this is what I found:

2020-05-07 11.27.54.jpg 2020-05-07 11.42.13.jpg

The toroidal inductor and load resistor had overheated.

Check the mechanics for something either binding or loose.

@Phaedrux said in Delta x and y not equal after firmare upgrade 2.05.1 to 3.1.1:

:
Thank you @Phaedrux, that change fixed issue with homedelta.g. I was just about to report the bug in the configuration tool but that has also been fixed. Nice work. The support for this board has been excellent.

@avery1701 said in BLTouch on Duet2Wifi / TEVO Little Monster:

That line was automatically generated by the configuration, but I am not sure what I selected to cause it to add the inverted zprobe flag.

On the IO mapping page in the z probe section you would have selected Input pin: zprobe.in (inverted)