Posts made by ansonyang

@dc42 https://www.aliexpress.com/item/1000007377570.html?spm=a2g0o.productlist.0.0.79bc231dBcsQSC&algo_pvid=7685f28d-8bc0-4f41-ac00-6200ee55258d&algo_exp_id=7685f28d-8bc0-4f41-ac00-6200ee55258d-0&pdp_ext_f={"sku_id"%3A"1000108751369"}&pdp_npi=2%40dis!USD!12.0!9.6!!!!!%402133f17c16672914432608735e3ac6!1000108751369!sea&curPageLogUid=d03Nm0gnDpXh&gatewayAdapt=4itemAdapt

hello everyone

How to connect the TMC2160 drive board to DUET3MB6XD

@dc42 After the BOOTLOADER is uploaded to the blank ATSAME54, the LED flashes slowly and the DUETBOOT disk is added, but there is no COM display on the motherboard. When the firmware UF2 file is copied to DUETBOOT, the LED flashes quickly, and then the LED turns off, and the motherboard does not respond.
Thank you

@tecno Sorry, maybe I didn’t describe clearly
I want to upload BOOTLOADER to blank ATSAME54

@tecno BOOTLOADER

Please share a BOOTLOADER of DUET3MINI5+? Thank you

I know that there is DUET3MINI5+, but Maestro is a good motherboard, suitable for entry-level 3D printers. Can I develop support for WIFI under the original circuit and remove the Ethernet.
good job

@iptronica
I encountered the same problem (the ENABLE line is allways at 3V3)
Can anyone help me

The price of DUET3 is beyond my ability.
I like DUET2MAESTRO very much, but TMC2224 is not what I want, I want more flexible drive support

@Veti I want to use a big drive to drive a big motor, not just DRV8825

@Veti Thank you my friend

@Veti I don't know, can you tell me?

I want to replace the TMC2224 on the motherboard with other drive modules

Excuse me
E2 and E3 external drive modules can work, but X_Y_Z_E0_E1 external drive modules cannot work.
Please help me

Thank you

I want to automatically turn off the power after printing

Thank you
Does DUET2MAESTRO have an automatic shutdown function after work?

If this is the case with an external drive module, how do I set it up?
Sorry for my bad English, translation software used

Hello, if I don’t use the onboard TMC2224, but use STEP and DIR on the board to connect 5 external drives, what should I do?
Thank you