Topics created by Amagatth

@droftarts Thx 🙂

@droftarts Thx for reply ! actually i active manualy ( with motion studio on PC ) and the motor move but on my printer i dont have a Pc to activate manually ENA haha

i go try with a relay on 24 v to try if its a wiring problem or just a setting

I have now implemented a fix (the same as Tim's fix) for this issue in the 3.5-dev and 3.6-dev source code, so it will be included in the next builds. I can provide temporary 3.5.2+1 builds if anyone needs them.

@Amagatth I suggest you try replacing the PSU and/or the cables connecting it to the Duet. A faulty mains cable is another possibility.

I try to update 6hc 3hc and screen with version 3.5.0 same on the panel due with 3.5.0 rc3 nothing change always stuck on connecting ...

@Amagatth and i have an other problem, duet 3 hc dont drive motor too,

I find solution for the 6hc Motor , the motor i swap with an other and its ok

@Amagatth
I think there should be several forum postings about temperature controlled rgb's.
One is:
https://forum.duet3d.com/topic/29269/temperature-controlled-led-display?_=1687167555573

@dc42 i check with my speed (1000mm/s-1200mm/s) i need 23.3v to have full torque 🙂

@Amagatth said in DSF Rockpi 4B Se on armbian:

@chrishamm hi , i have a new error 😕 spi reset always each second

Warning: SPI connection has been reset its the error message

Take a look here: https://github.com/Duet3D/DuetSoftwareFramework/wiki/SBC-Setup-Guide#spi-connection-reset

@Falcounet ok thx !!! i try it

@droftarts thx for the answer the problem is i have the sensor on 1 board and heater on other board, i change it and its perfect,

Same for the M140 i do it right 🙂 thx !!!!!

@t3p3tony ok i try it 🙂 thx !

@amagatth said in Sensorless homing problems:

RepRapFirmware for Duet 3 MB6HC version 3.1.1 running on Duet 3 MB6HC v1.01 or later (SBC mode)

Please use sudo apt update and sudo apt upgrade on the pi terminal to update your firmwares, etc to 3.3

@amagatth
That is correct.
If you're running RRF 3.3b2 you can use this version which uses variables, so it's easier to tweak as you don't have to search the full macro.
All the settings are at the top.

https://forum.duet3d.com/topic/22636/macro-to-call-heaight-map-based-on-bed-temp/1

i have change m671 with real screw coordinates and its look better ! 🙂 thx !!

@jay_s_uk thx!!

OK thx for the information I place an order for normal motor

Best regard

Controlling multiple beds will be a little more complicated. Typically heater 0 is the bed and heater 1+ is for an extruder and maybe a chamber heater. The slicers are only able to control the bed and extruder temp usually. So you'd have to control the second bed heater more manually. Perhaps treating it as a chamber heater, which some slicers can control.

I don't know what your printer is like or how it's used though, so I can't really give any specific recommendations.