Posts made by Amagatth

@droftarts Thx

@jens55 i want to fully independate axis to have a hight precision

@cosmowave yes 2 axis more on the X cariage to up and down each nozzle , u and V can be drive in G code when ask tool 1 or tool 2

@droftarts Thx for reply ! actually i active manualy ( with motion studio on PC ) and the motor move but on my printer i dont have a Pc to activate manually ENA haha

i go try with a relay on 24 v to try if its a wiring problem or just a setting

Hi all ,

Anyone have already set a système who have xyz standard on cartesian config but with 2 aditionnal Z for extruder so 2 extruder on the same carriage when you call t0 first extruder Go down and second stay at the top and when you call t1 second Go down and first Go top.

Need to creat 2 additionnal axis u and v right ?

@Maestro GUy , i just ask first to an utilisator who use the same driver.

A moderator tell me to open a post and ask, i ask .... i dont say i know , just ask to have a reply of the creator of other post.

@Maestro i open the post because phaedrux tell me to do it when i ask on the post. can map other pin for ena + on duet ? so if can't i just try a 24 V ith relay on ena but i first ask here to know if other pp try i and success activate with 5 v original of ena 1 xd on differential mod

@Maestro I have and 1 Xd connect to a 6hc. i connect ena signal from 1Xd to DI1 (com + / di1 )of an el6 750 step/dir version

On my other driver (t3d) 5V work on ena.

On this post https://forum.duet3d.com/topic/34181/wiring-ac-servo-drive-to-1xd ( t6 its the same driver than el6 but sell with stepper only brand ) the autor say it work

Hi all,

Im trying el6 servo on my printer but I have a problem , I have duet 3 6hc + 1xd ( 6xd on the futur when all work)

But I have a probleme with ena signal I active servo on with di1 and put wire ena + on com + and ena- on ena

I have 5v on send by the 1xd but the driver dont active moto I have to active it with Motion studio manually

Anyone have already solve this problem ?

Thx

Hey , i have the same driver like you but i have a problem with the ena, i put ena + on com + and ena - on si/di1 with d1 assign to serv on but it dont work , how you wire it plz ?

@droftarts i apply the new .bin file and it work perfectly !

@Amagatth it work ! now m18 engage break !

@timschneider thx for the file i apply it

@timschneider thx i try to put your file but i am on 3.5.2 it work ?

@droftarts if i understand this post he say effect is on duet 3 expansion board ... i have my motor on the duet 3 6hc

@droftarts no if i make a m18 moto are disable but dont active 24 v for brake

@dc42 Its ok i put my card in 24 V i use a duet 3 6hc + 3hc with brake on duet 6hc and motor on 6hc

@droftarts i change my 24 V now the board is on 24V ( 48V before) so i can direct command brake with out 9 in 24V

and i delet the line no pb

@p8blr i found the same result , but reboot printer take some MS to active brake and the head go down during this time

@droftarts Hey how are you ? you see anything wrong ?