Best posts made by 900turbo

Hi Everyone ,
I am currently updating/overhauling a Builder Extreme 2000. With the following parts a Duet 3 MB 6XD , Raspberry Pi 4 Model B , PanelDue 5i , Duet 3 Toolboard 1LC , Revo Hemera XS , Duet Magnetic filament monitor and a BL Touch. I have removed the old MB and am now starting to wire the drivers to the new MB.
This is my first time ever working on a 3D printer so please be understanding if not everything seems logical!
I feel as if this may be the first Industrial Builder Brand printer to get a Duet overhaul?
Any advice or wisdom would be greatly appreciated
Thank You.

@jay_s_uk Okay I see , so for now I will just config Z1 for the "starter pack of code"
Thank You.

@jay_s_uk t=Thank you so much for the help , that worked perfectly!

@jay_s_uk This is what i receive when trying to tune.
Will take photos and post config.

@deckingman I swapped the bed out and nothing happened , started going over every single bit of wiring I will keep it short but basically there's a emergency stop switch on the case and one of the wires was not on all that well. Reconnected it then tried to heat the bed and it heated straight up. I still cannot move my any of my axis but the steppers LEDs now come on so i assume Its just an issue with my g code.
Major relief anyway as I thought there was a far more serious issue with a broken SSR or Relays.