Firmware Install Probs. after Pushing ERASE Button

CupaCabra

Hallo,
i have push the Erase Button on the 7" PanelDUE the Board are the Wifi Board 1.04
I have try the Fallback procedure #3

plug the usb into pc
jumpering the duet3d board (erase jumper)
tap the restet button
open the SAM-BA V2.17 Software
(COM7)
choose the Duet2CombinedFirmware.bin (Release 2.02beta1)
Send the file
Klick Ok for regions
Compare and send file tke a issue
"Sent file $ Memory area content ("")do not macht !

i don´t konw wahts going wrong

can someone help me.

thx

dc42

Why did you Erase the main firmware on the Duet? It's only necessary if updating the Duet firmware the normal way fails and leaves the Duet not working.

Did you remember to remove the Erase jumper before sending the file? If you leave the Erase jumper in place then programming will fail.

CupaCabra

So, thx 4 the answer.
i have fixed the prob. There didn’t was a SD card in the slot. I have copy the file structure on the SS Card and Start the the firmware installation again and it works

dc42

I'm glad you got it fixed.