Firmware 2.01, resume after Heater fault isn't working
-
So I got this "Heater fault", fixed my heater, M562 it and now when I M24 it says "Error: M24: Cannot print, because no file is selected!".
/sys/resurrect.g was generated, but resurrect-prologue.g wasn't, so M916 also doesn't work. -
File resurrect-prologue.g isn't generated, you need to create it yourself. See https://duet3d.dozuki.com/Wiki/Setting_up_to_resume_a_print_after_a_power_failure.
I'll look into the behaviour of M24 after a pause caused by a heater fault.
-
Thanks for pointing me to the manual, looks like there is much more to learn for me
-
I've tested M24 after a heater fault pause using the forthcoming 2.02RC4 release, and it's working for me.
Please note, when a heating fault pause occurs, you have a limited amount of time to correct it before the machine shuts down and abandons the print. You can configure this time using the M570 S parameter.
