Custom splash screen

dragonn

@dc42 no the best solution but could we disable that rotating and just burn the image into the firmware upside down when needed?

Phaedrux

Since this is a bit of a vanity feature isn't the point of it all to be displayed?

dc42

@dragonn said in Custom splash screen:

@dc42 no the best solution but could we disable that rotating and just burn the image into the firmware upside down when needed?

Yes, but that would be harder to support.

dragonn

@dc42 Maybe when pressing rotate/mirror in settings the firmware would rotate the image in flash memory? This would take some time for sure, but then the image would be ready to load at booting without doing the math every time.

dc42

@dragonn said in Custom splash screen:

@dc42 Maybe when pressing rotate/mirror in settings the firmware would rotate the image in flash memory? This would take some time for sure, but then the image would be ready to load at booting without doing the math every time.

That's not possible because the image is compressed. It would need to be expanded, then re-compressed using the new pixel write order - and there isn't enough RAM to hold the uncompressed image.

dragonn

So maybe just an option in settings with allows users to disable automatic rotating of the start logo so it loads faster? By default it would enabled and load slow.
Of course, this is of little importance.

jml

@Phaedrux Yes I like it as a vanity feature - so ideally, I would like the logo to appear (fast), and then to not disappear until I press somewhere on the screen.

Phaedrux

@jml I wouldn't mind that.

jml

Its been a long time since I did anything with my 3d printer. I'm wondering if anyone here knows if the splash screen loading has been done any faster since this thread? If so I may load the new firmware if its is faster or if there is any other attractive reason to.

dc42

Yes it's faster in the latest firmware because the rotation and mirroring are done in hardware now.

jml

@dc42 awesome, thats great to hear!