Z Probe Help
-
Hi
The Z probe that I have doesn't have the identification sticker on it, but I believe that it is an SN04-N ( NPN NO ),
but It could be an SN04-N2 ( NPN NC).
I believe it to be normally open because if I hook it up as a normal endstop switch it will work as a open switch.The problem is when I hook it up as per WIKI instructions, Blue wire to ground, Brown wire to 5v, Black wire to cathode end of a
Bat85 Schottky diode, anode end to E0 stop pin.
The probe when triggered reads 0 on the Duet Web Control, and reads 1000 when untriggered.
That makes it seem like a normally closed switch. The wiki doesn't address normally closed probes, that I seen.
If I change the M574 E0 S0 to S1, were I'm guessing that the S1 = active high endstops, nothing changes.So…What am I doing wrong?
Here is my firmware settings
; Endstops
M574 X1 Y1 S1 ; Set active high endstops
M574 Z1 S2 ; Set endstops controlled by probe
M574 E0 S0 (S1)
M558 P4 H5 F360 T6000 ; Set Z probe type to modulated and the dive height + speeds
G31 P500 X0 Y0 Z4 ; Set Z probe trigger value, offset and trigger height
M557 X50:271 Y35:271 S20 ; Define mesh gridThanks for any and all help.
Steve -
Add parameter I1 to the M558 command.
-
AH Ha!!
Thanks dc42. That fixed it.
