Delta XY calibration
-
Hi
I just upgraded my Delta printer from Ramps to Duet ethernet.
everyting seems to work fine.except, my dimentions are off (they were pretty good before the board change)
I have done the autotune routine, using BL Touch (and got it to 0.014)
I know, that I can change the Rod length to tune XY, but the strange part is, that I have different offsets in X and Y (0.8mm in X 0.4 in Y over 100mm)
Are there any other parameters, that can get me to better dimentional accuracy?
-
-
this is an abolute offset right?
my offset seem to be scaling with the size of the printed object, so I dont think this is the right solution.
maybe this helps.. https://drive.google.com/open?id=1dmRbzW0ga1oKkvR33TSz4iv_SgwE46os
