Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    USB Host & Jumpers

    Scheduled Pinned Locked Moved
    Hardware wishlist
    2
    2
    669
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Adamfilipundefined
      Adamfilip
      last edited by

      DuetWifi
      Ability to load gcode via USB THumb Drive/Stick

      PT100 Daugher Board
      2 Pin Jumpers instead of solder points. when using 2 wire PT100

      1 Reply Last reply Reply Quote 0
      • T3P3Tonyundefined
        T3P3Tony administrators
        last edited by

        Hi Adam

        I will look at the PT100 board design again when we run another batch.

        The processor we currently use for the Duetwifi does not have the capability to be a USB host to thats not possible without changing the MCU. on the other hand you can use a USB-SD card reader so its only a slightly more onerous step to pop the sd card out and into the Duet.

        www.duet3d.com

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA