Solved CPLD Screens (Use off)
-
David
Due to recent issues I have been getting with My 7inch screen and PanelDUE V1 I have ordered a CPLD 7 Inch screen.
Is there anything I need to do to connect it or is it Plug n Play?
For sake of clarity the issue I have with the existing screen is that it can sometimes take 3-6 power cycles of the printer for the screen to initialise to the correct display. once it has initialised correctly it is alway fine when it doesn't it is just a mass of Greyscale lines.
Doug
-
Display arrived and connecting it to my PanelDue V1.0 with FW V1.20rc1 on it and the display doesn't initialise.
Any advise do I need to upgrade to a V3.0 board?
Doug
-
Did you install the CPLD build of the firmware?
I didn't write the CPLD display support, i accepted a pull request from another developer. So I don't know much about it.
-
Ah didn't even realise there was a specific build can you link to it please
Thanks
Doug
-
Thank you David for the Firmware file and the display is definitely crisper with the CPLD Panel although it hasn't cured my issue when it is on the printer and I suspect it is down to the 5V rail not having the guts to drive it (I have prob a 1.5 mar long loom) so I will re-wire it using some slightly heavier gauge wire for the Power lines for it and see if that makes any difference.
Failing that I can always feed it with an external 5V USB Cable till it has booted up fully
Thanks Again
Doug
-
So is this CPLD build available to download? I can't seem to find it.
-
yes it is now on the GitHub for the panelDue GitHub https://github.com/dc42/PanelDueFirmware/tree/master/Release/Edge
They are the ones with 7.0C in the titles
Doug
