Lost E value

[Fuzionline]

Good afternoon,

When I pause and then restore a print, everything works fine. However, if I restart the duet and run M916, it starts at the position where the pause was made, but it loses the E value from that line of G-code. Only when it moves to the next line of G-code does it start extruding.

Is it also possible to save the E value along with the (x, y, z) values, as if it were a pause and restore?

Thank you.

[dc42]

@Fuzionline the required extrusion should be restored already. Which firmware version are you using?

[Fuzionline]

@dc42
Hello tks

The version is RepRapFirmware for Duet 2 WiFi/Ethernet version 3.5.2 (2024-06-11 17:13:43) running on Duet WiFi 1.02

resurrect.g resurrect-prologue.g

[Fuzionline]

@Fuzionline
Good afternoon! Are there any updates?

[dc42]

@Fuzionline not yet, but it's on my list to look into next week.

[Fuzionline]

@dc42
hello
Do you have news
tks