Solved Allow Interruption of Heater Command

[CCS86]

It would be very nice if the "Pause Print" command were able to interrupt an M109.

I find on a semi regular basis that at the start of a print, I may want to change something or cancel the print. But if an M109 has already been issued, DWC is unable to interrupt this command and it must complete before allowing any intervention. I know that I could E-stop it, but allowing a graceful pause/cancel in these cases would be nice.

[dc42]

@CCS86 I believe this is working in firmware 3.5.0-beta.4. Please test and confirm or not. See https://github.com/Duet3D/RepRapFirmware/issues/763.

T3P3 created this issue in Duet3D/RepRapFirmware

closed Can't pause while bed or tool is heating #763

[CCS86]

@dc42 said in Allow Interruption of Heater Command:

@CCS86 I believe this is working in firmware 3.5.0-beta.4. Please test and confirm or not. See https://github.com/Duet3D/RepRapFirmware/issues/763.

Perfect, it is working!

Pause button "completes", which allows it to transform into the cancel button. The heater continues heating after pausing. The heater turns off if you then cancel.

(Sorry for duplicating the report)