Problem with all axis/motors (D3Mini+extension board)
-
@Maciek please can you try and take a clearer picture of U9:
-
-
This post is deleted! -
@Maciek yep that looks normal
-
Ok I know at least it's a D3m board issue. I borrowed duet mini from a friend. I plugged everything in and powered it up - it works as it should :/.
So for sure something with the board
-
Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.
-
Are you using the same mini2 board with the new mini5+?
-
Yes its same board.
-
Are there any measurement points on the board where I can check if everything is OK?
-
@domzduzt I think you should start a new thread and give some more information.
