What to add next?
-
I have successfully built my D-bot with a Duet Wifi and DeuX5. I have 3 independent Z motors, BLTouch, LEDs around the top for lighting.
Currently finishing up printing ABS parts to replace the PLA parts I initially built with on a DaVinci Mini. I have noticed a 200% quality increase with using the parts printed from my D-Bot than from that DaVinci.
I like to tinker, and add stuff, even if it's not necessarily needed.
What are some of your Duet additions to your printers?
I'm thinking a filament sensor using an endstop.
Looking for other ideas, as I have a ton of open ports and such on my Duet and would love to start getting into the fun parts of this board.
One day, when I build an enclosure I'll add some fans for the enclosure, and a temperature sensor on it as well. But that's going to be a little while down the line.
-
IDEX perhaps?
-
3 or 5 colour mixing hot end (of you have a masochistic streak)? A few thermostatically controlled fans for cooling electronics or motors? RGB LEDs? Filament sensors?
-
I am currently building a similar setup and working my configuration files at the moment. I am currently debating the following upgrades.
- Dual Bowden Y-splitter setup for dual colour printing
- LCD Display of some kind
- Magnetic removable build platform.
- Fillment sensors.
-