Spindle ON/OFF and speed control issues Duet 3

[jay_s_uk]

@peteupshall yes, it just a case of adjusting the screw on the PWM converter.
You need to set the minimum RPM in M950. I think the spindle I have has a minimum RPM of 6000

[peteupshall]

@jay_s_uk Minimum rpm is currently set to 0, should it be something else then?

[jay_s_uk]

@peteupshall yes. more than likely there will be a minimum RPM that your spindle can work at, set it to that

[peteupshall]

@jay_s_uk Minimum RPM on specs is 0 but have tried it at 600 but still the same.
If I adjust the 12000rpm it knocks the 24000rpm which is spot on, would it be an innacuracy with the 0-10v converter?

[Nightowl]

@jay_s_uk
That might depend on the milling motor or spindle.

I (now) know the Sorotec and Mafell have a minimum speed of 4,000RPM, but the AMB/Kress does go down to 0.

I'm not sure about water/air-cooled spindles, though.

[jay_s_uk]

@Nightowl mines a water cooled one. no idea what spindle is being used here

[peteupshall]

@jay_s_uk Hi 1.5kw aircooled spindle

[jay_s_uk]

@peteupshall itll probably have the same minimum RPM as mine then, so 6000

[peteupshall]

@jay_s_uk Still no joy. Set it to 6000 and M5 still wont make it stop. Tearing my hair out now as I cant get my head arround whats going on. Could it be a VFD setting?

[peteupshall]

Sorted it and dancing around the workshop .
Looked at all the frequency settings on VFD and noticed that PD011 was set to 200.00. Set it to factory 0 and it all works.
Thanks so much for all your help. This forum is invaluable.