Error: short-to-ground reported by driver(s) 1
-
Hi,
Sorry for recreate a topic on this subject but i've got a problem with my duet 3 mini 5+ ...
I'm working on a ratrig V-core 3 (coreXY printer) and i'm currently setuping the printer on DWC but i had firstly a problem with the 4th driver, the message "Error: Short-to-ground on drivers 4" appeared when i tried to homed my Y and X axes so i just fixed this error with an other cable and it worked good. But now, i've the same message with the first driver wich drive 1 of the the 3 Z axe motors.
So i also tried with an other cable but nothing, i tried with an other motor but nothing, i tried to change the connector but nothing again... And what scares me the most is when there is nothing plug on the first driver, i still recieve the error's messages every 5 seconds...
I'm not at all an expert with this subject so it could be very nice for me to know i can i do to fix this driver's problem !
I saw on a post that some mothercard coulb have this problem for no reasons so i hope i'm not on this case !
Thanks in advance for your answer
-
@aodrennn if you get that error when nothing is plugged in thats not a good sign. when and where did you buy the board?
-
@jay_s_uk Thanks for your fast answer ! I bought this card in september with my ratrig order !
-
Can you post a high quality close up photo of the driver chip area?
-
Hi @phaedrux, hope the pic is good for you, thanks for your help
-
Thanks. Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.
-
I'll do that, thanks again for your help !
