max31865 with duet 2

KevinSant

help with pinouts

T3P3Tony

The up to 4 MAX31865 chips are supported on the temerature daughterboard header, using CS pins CS1,CS2,CS3 and CS4. If you are using our PT100 daughter board then CS1 and CS2 refer to the MAX31865 ICs on the first daughterboard and CS3 and CS4 refer to the second daughterboard.

In RRF 3.x you need to setup the temperature sensor
to use the appropriate CS pin
https://duet3d.dozuki.com/Wiki/Gcode#Section_M308_Set_or_report_sensor_parameters
e.g.

M308 S1 P"spi.cs1" Y"rtd-max31865" A"PT100_1" ; define a PT100 sensor on the temperature daughterboard header, CS1

KevinSant

so this is the board I have I know it's not the duet but it's still the 31865 I'm just trying to figure out if my wiring is correct

max31865 / duet wifi 1.04

vin/ ?
gnd/gnd
3v/3v
clk/sck
sdo/Miso
sdi/mosi
cs/cs1
rdy/not applicable

so I pretty much got it figured out just need to know what vin gets connected to 3v on duet or stays open with nothing

pipersw

@bks31 you connect VIN to 5v and not connect 3.3V or you leave VIN not connected and connect 3.3V to 3.3V of Duet

T3P3Tony

yes that looks right and use 3.3V so the signal levels are correct for the Duet.

KevinSant

ok so leave vin alone then?
also I have two of these boards will I be able to stack them on top with same pins except the cs pin and use cs2 for another board

dc42

@bks31 said in max31865 with duet 2:

ok so leave vin alone then?
also I have two of these boards will I be able to stack them on top with same pins except the cs pin and use cs2 for another board

Yes.