PanelDueFirmware 3.2.8 released

BoA

@wilriker There is something strange going on in this firmware...

https://www.youtube.com/watch?v=_dw5heELJEw

wilriker

@BoA please provide the output of

M409 K"heat" F"d99vn"
M409 K"tools" F"d99vn"

BoA

Commands executed during print.
console.txt

Seems there is some relation with bed heater and tool1:
https://www.youtube.com/watch?v=E9w-VdB8ghc

T1 state "blinks" with the same state as heatbed.
On video it is on stby, but making it active makes T1 blinking in red also.

And after pressing Emergency Stop:

Stephen6309

@wilriker Sent M997 S4, and I get: Error: M997: Network-related commands are not supported when using an attached Single Board Computer

Duet 3 Mini with 3.2 and a Pi4.

oozeBot

I’ve also seen my macros blank out like that this am after upgrading to 3.2.8 and the rapid blinking of temps like in your video.

flopo76

Thanks,when Italian language?

MartinNYHC

Same here...

If you touch the field once it is shown properly again.

wilriker

Thanks all for reporting and confirming. I will have a look at these today.

wilriker

@flopo76 said in PanelDueFirmware 3.2.8 released:

Thanks,when Italian language?

I don't speak Italian so unless someone is willing to translate the strings at https://github.com/Duet3D/PanelDueFirmware/blob/master/src/Strings.hpp#L123 there is not much I can do unfortunately.

wilriker

And I released PanelDueFirmware 3.2.9 that hopefully fixes all the mentioned issues. It turned out that the bug with broken macro buttons was in fact a side-effect of the status-bug and I could no longer reproduce it once I fixed the that.

Please continue in the other thread and apologies for the numerous releases.