E3D Titan Bowden Extruder setting up

[AS-3D Druck]

Hey Guys,

i'am the Owner of a Duet Wifi + e3D Titan (Standard Motor) and I am not quite sure if it gets enough "mA".
Currently it's getting this: 800 mA

Is this enough or sould it be adjusted?
By the way it is in use as a Bowden Extruder.

Hope you can help me.

[Dougal1957]

that all depends on which motor you are using

but try it and see

[dc42]

E3D should tell you what current setting is appropriate for their motor. But if it's the new one with 42BYGHM208P4.5-15-X2 on the label, the datasheet I found here http://www.promoco-motors.com/products/StepperMotors/42BYGHM%20Series.pdf says it is rated at 1.2A. So if it is skipping steps, you could increase the current to 1000mA.