Zesty Nimble config?
-
I think the M350 default's to those settings which is why I didnt point it out
-
Alternate problem might be that the stepper is rotating too slowly to show. It needs to rotate at a nice pace.
-
After quite some investigations it turns out that the stepper can only rotate very very slowly.
Despite the fact that the config is correct in this matter.What could be the cause of a stepper only being able to rotate so slow? Even when running free?
Could this be a wiring issue? -
What are the specifications of the stepper motor?
-
Extruding at 5 mm/sec the normal revs for the stepper should be around 260 RPM.
-
I will ask what stepper it is.
But time difference means it will be tomorrow before I have an answer. -
I have Wantai motors (42BYGHW811P1), 1.8° with a rated current of 2.5a does that help?
-
I have Wantai motors (42BYGHW811P1), 1.8° with a rated current of 2.5a does that help?
What do you have the extruder motor current set to in the M906 command? 2000 to 2200mA should be about right. If you exceed 2000mA, cool the Duet with a fan.
-
I have Wantai motors (42BYGHW811P1), 1.8° with a rated current of 2.5a does that help?
What do you have the extruder motor current set to in the M906 command? 2000 to 2200mA should be about right. If you excgeed 2000mA, cool the Duet with a fan.
I have it set too 500mA as recommended by the nimble setup page
-
All is resolved and the printer is printing fine now.
Ed and Brian worked together and figured it out. Reflashed the Duet and now it is printing at normal speeds.Nice to see 3 continents working together to make things work.
Lykle
