[3.2-beta-3.2] Strange pauses during print

[Phaedrux]

Thanks for testing. Definitely an exaggerated pause there.

[Phaedrux]

Each time you run M122 it clears the hiccup counter.

[BoA]

@Phaedrux I am aware of that. Just in the middle of print, each m122 reported 0 hiccups, and just after pause over 16000, after another pause (longer one) almost 50000. And other thing is this platform slowest loop significantly higher than normally.

[BoA]

This post is deleted!

[BoA]

@Phaedrux I just tested this particular print with 3.2beta4, and there ar even more pauses and for longer time, than with 3.2beta3.2

After each pause I gou a hiccups counter from 0 to around 30000. Between pauses hiccups counter is 0 all the time.

As I can not see anything from @dc42 I am guessing he just missed that.

[dc42]

@BoA, please post the file you are printing and your config.g file.

This may be related to https://forum.duet3d.com/post/195269.

[BoA]

@dc42 I posted before, but:
config.g
gravitrax_dual_support_0.2mm_PETG_52m.gcode

[dc42]

Thanks. I confirmed and fixed this issue. I have put new RRF 3.2beta4+3 binaries at https://www.dropbox.com/sh/tehhdvunh0pgr7q/AADgJ4Qj7W18MYaRRNNDdhpwa?dl=0.

[BoA]

@dc42 Confirmed: No more pauses during print. Zero hiccups, and some 3 underruns?

=== MainDDARing ===
hiccups 0, stepErrors 0, LaErrors 0, Underruns [0, 0, 3]

Anyway - prints with no issues now.

[dc42]

Thanks for confirming. I will mark this as solved.