Problem setting up core XY

You need to load the saved mesh or re-probe the entire bed before the print is started. This means adding G29 S1 to the slicer start gcode after the G28 that homes the printer.

Veti

@Veti

here is a crude fix for your belt problem.

run the belt through the hole from behind and have a loop out in front.
put a bolt (a large screw or something) through the loop to stop the belt from pulling out.

here is a fix i did for this on the plastic parts

Veti

@Phaedrux
he posted in this thread by accident.

Phaedrux

@Veti said in Problem setting up core XY:

@Phaedrux
he posted in this thread by accident.

Oh well, I still answered on purpose.

mmartin

@Phaedrux is there a way to add bed heat before the homing and also bed probing? My sensor needs the bed to be heated to produce accurate results. I've been doing it manually but it would be nice to automate this process as well.

Veti

@mmartin
please dont hijack other peoples threads with different probems.

mmartin

@Veti ummmm ok...

Veti

@mmartin

it gets confusing.
as you can see you already confused @mrehorstdmd

mmartin

@Veti said in Problem setting up core XY:

@mrehorstdmd

My original reply was within context of his post about the bed origins. Regardless have a good one!

william3d

@Veti M669
Kinematics is CoreXY, matrix:
1.00 1.00 0
1.00 -1.00 0
0 0 1.00

Veti

@william3d

can you move any of the belts by hand while the motors are energised ?

william3d

@Veti When the motors are on After homing and energized I cannot move by hand

mrehorstdmd

I'm easily confused.

The belt angles don't look so bad from above.

What are the motor specs?

Veti

@william3d said in Problem setting up core XY:

X Moves correctly
Y Moves correctly

The web controller shows example X25 Y25 I move to X25 Y200 The web controller shows X25 Y200 but You can tell X has moved to 150 and Y is at 200.

i am also getting confused as this does not match

could you please restate your problem.
stating exactly which command you are issuing.