Attempting to extrude with no tool selected

[fcwilt]

Hi,

Did you select a tool first?

You can do this from the web interface.

Or you can add a T0 command to the end of your config.g file.

Frederick

[Elvis0z]

I'm not sure how to do this. What command do I use? Thanks for the help

[fcwilt]

I'm assuming you know how to navigate around in the Duet Web Control (DWC) interface.

See attached to where you can click to select a tool.

Or you can execute a T0 command from the DWC or add it to your config.g file.

Frederick

[weed2all]

Just open your config.g file and add T0 at the bottom of your config.g

[Elvis0z]

Thanks guys, I'm such a noob lol. Well I'm learning.

[Phaedrux]

@Elvis0z said in Attempting to extrude with no tool selected:

M350 E256 I0 ; configure microstepping without interpolation
M350 X16 Y16 Z16 I1 ; configure microstepping with interpolation
M92 X80.00 Y80.00 Z80.00 E96.00 ; set steps per mm

I think you may also have an issue with your steps per mm and using x256 microstepping. I suggest you change to x16 microstepping with interpolation enabled on E for now.

[Elvis0z]

@Phaedrux said in Attempting to extrude with no tool selected:

M350 X16 Y16 Z16 I1 ; configure microstepping with interpolation

How would I do that?

[fcwilt]

@Elvis0z said in Attempting to extrude with no tool selected:

@Phaedrux said in Attempting to extrude with no tool selected:

M350 X16 Y16 Z16 I1 ; configure microstepping with interpolation

How would I do that?

You have a command M350 E256 I0

Simply delete that line and add E16 after the Z16 in the M350 line below.

Frederick

[Elvis0z]

Thanks heaps Phaedrux.

[Elvis0z]

@fcwilt Thanks fcwilt