Just want to add one more Z stepper, for a total of 3.
-
@Steve-Lynch What about using the Duex2 instead of the Duex5 ?
-
$79 vs. $34. I mean if I have to buy one, I will, I just wanted to see if the simple expansion board would work. I don't need any additional fans, or sensors.. just one more little stepper!
-
add an external stepper via the main header
-
@Steve-Lynch I'm not 100% but fairly sure that the expansion board is for using external drivers so it doesn't have any of its own. If that's correct, then you have to factor in the cost of a driver as well.
-
Hmmm. That's not scary, if that's the case! I have 3 drawers of my parts bin stocked with TMC 2208, 2209, and 2130 drivers for all of my farm printers. I have a buddy in China, and he hits the electronics marketplace frequently, so he usually snags me a couple sets of steppers, and drivers, as well as a few MK52 heat beds. They're like 1/3 the price of even alibaba. I guess I need to study the header diagram... I might just try it for kicks. laser cut a little driver holder, and wire it up with Duponts to the header. If it doesn't work out? Duex 2 it is! Thanks guys!
-
@Steve-Lynch Found some more info on the expansion header https://duet3d.dozuki.com/Wiki/Duet_Expansion_Breakout_Board
-
@Steve-Lynch said in Just want to add one more Z stepper, for a total of 3.:
I might just try it for kicks. laser cut a little driver holder, and wire it up with Duponts to the header.
should work provided the driver can work with 3.3v signals even if it might needs 5v supply. (if you want to use smart drivers it needs to be the same tmc2660 as is on the wifi and the spi1 signals are 5v already)
-
@Steve-Lynch, have you seen https://duet3d.dozuki.com/Wiki/Using_external_stepper_motor_drivers#Section_Connecting_Pololu_style_drivers ?
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42 No sir, thank you.... I have no problem with ordering a Duex, but they've been backordered at filastruder, and I just want to get this done. If I can cobble it together in the meantime, great! However, I also do not want to cook a perfectly good duet by "tinkering"....
-
DueX boards are currently being manufactured, so they should be available again soon.
