please custom firmware for duet2wifi+ender3pro+bltouch
-
If someone have the same setup its be great for me if isend me is configuration file thnks
-
Hi
If you go to the RRF Configurator RRF Config
there is a config for ender 3 pro ready for you to tab through when you get to the endstops tab click the BLtouch to set it up
all the hard work has been done for you . -
@stewwy cool Thank you I haven't received the board yet, I should probably understand that it works differently from old fashioned Merlin, I'll get it in the next few days and try thank you
I'm glad things are so simple in reprap frimware -
@stewwy isee this page https://configtool.reprapfirmware.org/Start
all the config for ender 3 is ok just need to change for bltouch setting?
isee this video https://www.youtube.com/watch?v=HxEk7-6RriQ
and is setting not the same .It confused me a little -
You may find this series of guides helpful. It's based around the Maestro, but things are largely similar for the Duet wifi.
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+1:+Wiring/37
