Problem with Tool Fan

toddel

Hi.

i have a problem with my tool fan...

I want it to run with 100% after Hotend is over 45°C.

While printing the fan goes down to 15 like the part cooling fan...

What did i wrong?

; Fans
M950 F0 C"out7" Q10                          ; create fan 0 on pin out7 and set its frequency
M106 P0 C"Hotend" S1.0 T45 H1                ; set fan 0 name and value. Thermostatic control is turned on (45°)
M950 F1 C"out8" Q10                          ; create fan 1 on pin out8 and set its frequency
M106 P1 C"Radial" S0 H-1                     ; set fan 1 name and value. Thermostatic control is turned off

; Tools
M563 P0 S"Mosquito" D0 H1 F0                 ; define tool 0

Phaedrux

How do you have the fans wired?

aidar

You messed up your fan definitions and terminology. Tool fan is part cooling fan, not hotend fan. As i see from your config, your "Radial" fan is part cooling fan, so you should define that fan with tools. Change F0 in M563 to F1 and try again.

toddel

Hotend Fan should be named as Heatbreak Fan... Radial is the part cooling fan