Could you share your config.g?

Thanks/Danke

Is there a plan/howto/manual, how to set up and fine tune a printer from zero?

Accel, jerk, PA, Input Shaping, Currents etc etc etc? For every possible tuneable setting…

To get a very decent print and perfect benchy

Hi guys.

Is a Connection via ribbon cable from duet mini to Raspberry possible or only over usb?

I have a mini5 in sbc mode, if i use it in standalone, is a Connection over that cable possible?

@cosmowave das duet 3 mini5+ wifi

Hallo...

ich schreibe hier auf Deutsch, weil ich die ganzen englischen Anleitungen zwar verstehe, aber irgendwie auch nicht. Da werden mir irgendwelche Parameter vorgeklatscht, mit denen ich nichts anfangen kann.

Kann mir jemand erklären oder ein Tutorial zeigen, wie ich den Stealthchop einstelle? Bislang hört sich Z ziemlich laut an.

Vielen Dank vorab...

Hi...

Pretty new to the mini 5 wifi. I run it in sbc mode on V3.3 now.

How to upgrade to the latest 3.4 beta?

"unstable feed on the Duet3D package server" - what does that mean? Is there a manual for that?

Thanks in advance

@paulhew

Got it working! Thank you all!!!

@paulhew Thanks...

Do you have a source wich pins are needed?

@paulhew Interesting, can you share a picture?

Hi...

soon i get my Duet3 Mini 5+ and i have a Pi3b+ in my setup. For now i power the pi with a stepdown to the GPIO Pins. When i connect the Duet Ribbon the pins are hidden... The Duet can not power the pi.

Are the first 2 Lines in the ribbon cable for 5v and ground? So i could cut the two lines on the Duet side and put them in the Stepdown? Anybody did that already? I don't want to power via USB Connector (optic ;)).

Or could i leave the Ribbon Cable as is and solder cables for + and - on the bottom of the gpio Connectors on the pi?