Tool0 can't be deselected manualy in RRF3?!
-
Hello,
i detected a issue which wont deselect Tool0 manualy.
First off my configuration, i using:-
Board: Duet Ethernet 1.02 or later + DueX5
-
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.01-RC4 (2020-03-16b1)
Let's say Tool0 is already active and i want to deselct it i typed in the DWC "T-0" to deselct Tool0, nothing happens. If i press on the "Heater1" or "T0" sign, the Tool0 will deselct and set to Standby like it should happen. So i wonder is there a difference between T-0 and pressing Heater1 or T0 in the DWC?
Then i activated the Tool1 and typed in the DWC "T-1" the Tool1 will be deselected like it should. It seems that it only doesn't work for Tool0.
Does anybody have a explanation for this behavior?
-
-
This is expected. T-1 is a tool code with an invalid tool number, so it will deselect any tool regardless of the currently selected tool.
-
@Philipp-R said in Tool0 can't be deselected manualy in RRF3?!:
Let's say Tool0 is already active and i want to deselct it i typed in the DWC "T-0" to deselct Tool0, nothing happens.
-0 and 0 are the same number, so T-0 does exactly the same as T0 does. Use T-1 to deselect whatever tool may be selected.
-
Ok so i did miss understand the concept of deselect tools.
Thank you very much for the help and quick reply.
