M291 doesn't seem to do anything - RRF3.01-RC3

[jay_s_uk]

I'm just getting into calibrating my extruder using nonlinear extrusion.
I'm using this macro to tune it.
When I run it, the M291 instructions are ignored and the macro runs straight through.
I tried running the first M291 in its own macro and when its executed, nothing is displayed.

This happens on a duet 3, with SBC attached running DSF 1.2.4.0 and firmware 3.01-RC3

Running the same file (and shortened macro) works on a duet 2 running the same firmware

[dc42]

M291 is not yet supported when using the SBC.

[jay_s_uk]

Damn.

I take it all I can do in the mean time is run it all independently?

[dc42]

If M291 is essential to you, unfortunately yes.

There is a major upgrade to DSF due later this month, which may include M291 support.