Upgrading RR3 via DWC 2.0.7 to a later version of RR3 error
-
Every time I upgrade RR3 from a previous version of RR3 via DWC 2.0.7 (system\upload system files) I get the following error messages in the console although the upgrade is actually successful...
28/02/2020, 09:26:17 Error
Operation has been cancelled
28/02/2020, 09:26:17 M997 S0
Operation has been cancelledrunning the M115 command after the upgrade via the console proves that the upgrade was a success but I don't understand what is causing the errors?
28/02/2020, 09:34:43 M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 Maestro FIRMWARE_VERSION: 3.01-RC2 ELECTRONICS: Duet Maestro 1.0 FIRMWARE_DATE: 2020-02-18b1 -
When do you get those messages: is it immediately after you have accepted the invitation from DWC to install the new firmware?
-
@dc42 said in Upgrading RR3 via DWC 2.0.7 to a later version of RR3 error:
accepted the invitation
I accept the invitation to upgrade then it goes through the upgrade process and only outputs the error messages in the console as it completes the process.
-
@Spanners said in Upgrading RR3 via DWC 2.0.7 to a later version of RR3 error:
@dc42 said in Upgrading RR3 via DWC 2.0.7 to a later version of RR3 error:
accepted the invitation
I accept the invitation to upgrade then it goes through the upgrade process and only outputs the error messages in the console as it completes the process.
Are you running with an attached single board computer, or in standalone mode? If with SBC, what version of Duet Software Framework are you using?
-
I'm communicating with the Duet 2 Maestro over an Ethernet link connected to my router, I use a wireless laptop to connect to the DWC so stand alone I think is the answer your looking for.
I don't know what a single board computer is unless you mean the likes of a Raspberry pi which is not what I am using?
-
Sorry, silly question.
Those messages are coming from Duet Web Control, but I don't know why. One for @chrishamm.
