Overview of implemented Gcode RRF3 for Duet3+Pi

mvieleers

Is there an overview available of all Gcodes that have been implemented in DWC for a RRF 3(.01-RC2) Duet3+Pi combination?
I've ran into a situation that M500 has not been implemented, but I also noticed that M291 is not working.
It would be helpful to understand what can and cannot be used.

Thank you!

Phaedrux

Something like this?

https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview

A Former User

Its the best overview available, but its not perfect - M291 was only added recently. Do post if you find other exceptions.

DocTrucker

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

A Former User

@DocTrucker said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide.

sure it is;)

i think its related to the fake sd card not sure.

deckingman

@bearer said in Overview of implemented Gcode RRF3 for Duet3+Pi:

.................................Do post if you find other exceptions.

As of latest firmware release (3.01-RC2), M950 now has a J parameter. These have all changed too as per the "What's new"

If you use M577 or M581 commands, you will need to change them.
If you use M143 commands with P or X parameters, you will need to change them
If you use M558 commands with the I parameter, you will need to change them

but the overview that @Phaedrux linked to doesn't reflect the changes

gtj0

@DocTrucker said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

M500 doesn't work with the DSF/SBC for any heater because we're waiting on @chrishamm to implement support for getting the values from the Duet and writing them to the config-override file. AFAIK it works in standalone mode (at least for local heaters).

mvieleers

@Phaedrux thx! Read a lot, but never stumbled upon that page strangely enough.

DocTrucker

@bearer nice one...

But I searched document for "M500". [checks edit history] Ah ha!

chas2706

@gtj0 said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

M500 doesn't work with the DSF/SBC for any heater because we're waiting on @chrishamm to implement support for getting the values from the Duet and writing them to the config-override file. AFAIK it works in standalone mode (at least for local heaters).

I hope @chrishamm remembers to sort G32 not reporting any output and having to enter commands in the console twice before they work!