IDEX U Axis not reporting location in web control?
-
Hello,
I am working on an IDEX machine. I have noticed that the U axis is not reporting the position of the U axis. I can do a M114 and the position is reported correctly however that is not being displayed in the DWC2. Is this a bug or did I not do something correctly? That is quite possible as I am still very new to Duet and RRF.Thank you in advance
Walter
-
There is a very similar discussion at https://forum.duet3d.com/topic/12407/dwc-2-0-2-u-axis-not-showing so I am asking the same questions:
What response do you get if you send M408 S2 ?
Which firmware version are you using?
-
here is what I get from a M408 S2, Also I am running 2.04RC3
-
Would rolling back to 2.03 be better?
-
@Wallabear said in IDEX U Axis not reporting location in web control?:
Would rolling back to 2.03 be better?
From the M408 S2 report, I don't think the issue is in RRF, I think it is in DWC 2. So try appending /reprap.htm to the IP address in your browser, which will run whatever version of DWC 1.x is on your SD card.
-
@dc42 thanks you for the help I will give it a try. I do not have a previous version of DWC1 on my sd card at the moment when I get a chance later I will download a version of it and put it on there.
-
@Wallabear said in IDEX U Axis not reporting location in web control?:
@dc42 thanks you for the help I will give it a try. I do not have a previous version of DWC1 on my sd card at the moment when I get a chance later I will download a version of it and put it on there.
I suggest version 1.22.6.
