Warning: motor phase A may be disconnected reported by driver(s)

Cata

@dc42 tested in all 2.03 betas and 2.02 stable.
Motors are low current, no data of the model or manofacturer.
Connected in parallel today, same warning with some "largue movements", 25 - 50 mm in one command.
Cant use another driver, dual extruder is setted

Veti

@cata
try reducing the maximum speed of the z axis.

supernovae

@dc42 I am running latest firmware when i get this warning - only on faster movements. WHile printing i'm not seeing it.

Cata

@veti from 360 to 180 and now dont see the warning.
Then i cant use motors in series? Whats the point of the warning if my motors works well?

Veti

stealthchop2 has drastically reduced torque on 12v. you will need to upgrade to 24v.
there is an extensive video about it. https://www.youtube.com/watch?v=GVs2d-TOims

supernovae

I'm already 24v

dc42

@cata said in Warning: motor phase A may be disconnected reported by driver(s):

Same problem here. 2 nema 17 in series, duet maestro, 12v, with all the currents, speeds and firmware versions.
Warning: motor phase A may be disconnected reported by driver(s) 2 going UP
Warning: motor phase B may be disconnected reported by driver(s) 4 going DOWN
Only stops whe using M569 P2 V670 or bigger value. But the motors are too noise to keep that value.

Driver 4 is the E1 motor output. What do you have connected to that output?

When you connected the motors in parallel instead of in series, were you able to use a larger M569 P2 V parameter without the motors becoming too noisy?

Cata

@dc42 said in Warning: motor phase A may be disconnected reported by driver(s):

Driver 4 is the E1 motor output. What do you have connected to that output?

Mistiping, both warnings are for driver 2

@dc42 said in Warning: motor phase A may be disconnected reported by driver(s):

When you connected the motors in parallel instead of in series, were you able to use a larger M569 P2 V parameter without the motors becoming too noisy?

No, same noise

dc42

I've changed the code in firmware 2.03RC1 to disable the open load detection when in stealthChop mode. I expect to release that version later today or tomorrow.

Cata

@dc42 Thanks, i dont run for this but prefer to avoid the warning flood.
I will test again the conbinations when release the new firm.