Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Even better solution: I hooked up the power wires for my laser to the bed heater output and made that a GPIO that I then turn on and off via gCode.
@gost101 That will be fine as long as you don't draw too much current for the 5 Volt supply or the connector you are using.
@sindarius Just tested and working well - many thanks!
@JDigglyWiggly I did it out of sympathy for a dad with 3 kids under 10.
@th3dtim This is a great Wiki, thank you!
I found a typo though... On your Motion Settings section, you have a header for M556 Command, but that code should be M566, as it also says in the description below it.
@mrehorstdmd thanks Im not going to use plastics nor heated nozzle 🙂
Thank you so much for your quick reply, that fixed everything!
