Hi there! I figured this would be good to post here as this forum is the official support method for Duet users. We got a few people using our EZABL kits with the Duet boards so we did a write-up on the recommended setup for our probes with the Duet boards.

You can see it here: EZABL Duet Board Setup Information - TH3D Help Center

I hope this helps people get the probes setup with the Duet boards. I had a heck of a time with the learning curve on the duet software. If there is anything I should change on the article please let me know. If one of the mods wants to just lock this post I just wanted it to be on here to serve as a reference to our setup guide article for EZABL+Duet customers. Thanks!

@Veti said in TH3D EZABL Setup Information:

do you really need the control board for the duet?

see
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_NPN_output_normally_open_inductive_or_capacitive_sensor

The control board provides isolation from the sensor and the IO pins. Definitely keep it. The signal is transmitted with a high-speed Opto IC on the control board.

@o_lampe Thanks for catching that. I fixed it.

Hi there! I figured this would be good to post here as this forum is the official support method for Duet users. We got a few people using our EZABL kits with the Duet boards so we did a write-up on the recommended setup for our probes with the Duet boards.

You can see it here: EZABL Duet Board Setup Information - TH3D Help Center

I hope this helps people get the probes setup with the Duet boards. I had a heck of a time with the learning curve on the duet software. If there is anything I should change on the article please let me know. If one of the mods wants to just lock this post I just wanted it to be on here to serve as a reference to our setup guide article for EZABL+Duet customers. Thanks!