DWC 2 g32 results

[Monster Delta]

hi how do i review the deviation result when i run g32 they don't seem to be displaying in the gcode console in DWC 2

[taconite]

see: https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer

When you are happy with the results, save the new calibration parameters. There are two ways of doing this:

Run M665 and M666 without parameters, then they will display the current parameters as adjusted by auto calibration. Copy the new values into the M665 and M666 commands in your config.g file.
If you are running firmware 1.17 or later, you can run M500 to save new M665 and M666 commands in the config-override.g file. Then, if you have an M501 command at the end of your config.g file, it will run config-override.g at that point, so that the new commands override the ones earlier in your config.g file.

[Monster Delta]

@taconite that's not what i mean, in dwc 1 when you run g32 and the probing has finished it came up with deviation before and after but in dwc 2 you dont get this information

[taconite]

actually you do

[Adrian52]

I don't see the result on the console

[dc42]

I have the same issue.

[Monster Delta]

@taconite what version dwc are you using

[Dougal1957]

With RC3 you get the results if you send G32 manual from the g-code input it doesn't work if you use the compensation dropdown option

[Monster Delta]

@dougal1957 thankyou

[Slumberjack]

I’ve found the same with about 50% of G32 and G30 S-1 commands. Been doing a lot of bed levelling lately.

DWC 2 and the latest firmware.